Felisatti RHF40/1100VERT Instrucciones De Servicio página 6

conductor
2
2
1 mm
2
Maintenance and Checking of Work Area
Switch Status Check
If the power plug is connected when the power switch
Check if the switch lever returns to its original position
OPERATION
1. Mounting the Side handle and Stopper(Fig. 2)
For operating convenience , the side handle can be
side handle properly assembled to maximize control of the
Mounting the side handle
section at the front end
Mounting the stopper
a hole the depth of the distance between the bit and the
2. Installing and Removing the bit CAUTION
WARNING! Wear protective gloves when changing bit
Installig and Removing the SDS-max bit
F40/1100VERT, RHF40/1100VERTM) (Fig. 3)
Clean the dust cap if necessary or have it replaced if the
3. Soft Start
slowly, thus preventing the drill bit from walking off the in-
also reduces the immediate torque reaction transmitted to
the gearing and the operator if the tool is started with the
4. Safety Clutch
6
30 m
40 m
60m
low for the relationship between the number settings on the
Controller knob
minut
minite
RHF40/1100VERTM) (Fig. 5)
the hammering-only mode, the tool only impacts the work
chiseling, and demolition applications
chisels and shapes chisels can always
-
(RH-
-
CAUTION! As soon as the safety clutch actuates,
5. Speed Change (Fig. 4)
1 2
235 265
1350 1520
6. Mode Select
RHF40/1100VERT, RHF40/1100VERTM
7. Adjusting and Fixing of Bit Angle (Fig. 6)
change the bit angle,
8. Indicator LEDS (Fig. 7)
9. Operation
Hammer drilling operation (Fig. 8)
Chipping and Chiseling
-
-
-
3 4 5 6
320 440 500
2530
(RHF40/1100VERT,
can be