Noise And Vibration - Felisatti RHF40/1100VERT Instrucciones De Servicio

Pressing very hard on the tool will not increase chipping
10. Operation time
11.VCS (Multi Vibration
(RHF40/1100VERT, RHF40/1100VERTM)

NOISE AND VIBRATION

circumstances the maximum noise level in the place of
work could exceed 85 dBA. In this case, the operator
should wear ear protection.
Use ear protection!
WARNING!
instructions has been measured in accordance with
uses of the device give rise to different vibration levels and
in many cases they may exceed the values given in these
if the electrical power tool is used regularly in particular
Note. If you wish to make an accurate assessment of
the vibration loads experienced during a particular period of
working , you should also take into account the intervening
periods of time when the device is switched off or is running
ACCESSORIES
Accessories and their corresponding order number
MAINTENANCE
1. Checking the Tool (bit)
2. Checking the Screws
Commutator may worn out quickly shortening the service
3. Maintenance of Motor Assembly
4. Storing after Use
Store the tool in a dry place out of reach of the
5. Repair
6. Cord
must be replaced by a specially prepared cord available
Control System)
relating to old electrical and electronic appliances and
its translation into national law, used electric tools must
in certain be collected separately and recycled in an ecologically
If the supply cord of this power tool is damaged, it
WARRANTY
See general warranty conditions printed on the
DISPOSAL
WARNING! Do not dispose of electric tools in the
household waste!
7