Important; Ac1300 Setup Requirements - Angelcare AC1300 Manual Del Propietário

16.13 Remove batteries from the Nursery Unit if
you store the product over 30 days because the
batteries could leak and damage the product.
16.14 Discard 'dead' batteries as soon as possible
since 'dead' batteries are more likely to leak in a
product. If a battery has leaked or vented, it should
be replaced immediately using protective gloves.
16.15 DO NOT store this product, or the batteries
provided with or identified for use with this
product, in high-temperature areas.
WARNING
17. (North America Only)
17.1 Warning: Changes or modifications to this
equipment not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
17.2 NOTE: This equipment has been tested
and found to comply with part 15 of the FCC
Rules and the Industry Canada license-exempt
RSS standard(s). These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
SETUP REQUIREMENTS
INCLUDED:
73 F
Rechargeable Parent Nursery Unit
Unit with enclosed
and non-detachable
lithium battery
YOU MUST PREPARE:
One hardboard (not included)
Thickness: 1/4'' (6 mm)
Minimum dimensions:
13'' x 13'' (33 x 33 cm)
Maximum dimensions:
equal to the mattress size

IMPORTANT

The hardboard must be larger than the Sensor Pad
surface area or in the case of the AC1300-2SP of
two Sensor Pads.
All manuals and user guides at all-guides.com
17.3 H oweve r, th e re is n o g ua ra nte e th at
inter ference will not occur in a par ticular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment OFF
and ON, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving
• Increase the separation between
• Connect the equipment into an
• Consult the dealer or an experienced
17.4 This device complies with the part 15 of
the FCC Rules and the Industry Canada license
- exempt RSS standards(s). Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
5
6
1 Sensor Pad (AC1300) or 2 Sensor Pads
(AC1300-2SP) with pre-installed cord covers
Hardboard
Batteries for Nursery
antenna.
the equipment and receiver.
outlet on a circuit different from that
to which the receiver is connected.
radio/TV technician for help.
VIDEO, MOVEMENT
& SOUND MONITOR
Model AC1300
3 2 1
4
WHAT YOU WILL NEED (NOT INCLUDED):
3X
3 AA Alkaline
Unit
E
N
2X
2 AC Adapters
Miniature Philips
Screwdriver
5