Grouw 68141 Manual De Instrucciones página 38

Minicultivador eléctrico
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 66
You can achieve the desired working
position by loosening the wing nut, tilting
the support grip to the desired angle, and
re-tightening the wing nut.
Use
Insert the plug (6) into an extension cord.
Make a loop with the extension cord and
feed it through the hole in the handle (4).
Attach the loop to the hook (5) on the inside
of the handle so that the plug cannot be
accidentally pulled out.
Insert the extension cord plug into a mains
socket.
38
Place the mini-tiller in the location where it is
to be used. Hold the mini-tiller by the handle
(4) and support grip (1) using both hands.
Press the safety button (3) and then press the
on/off button (2).
The blades (13) begin to rotate immediately.
Press in the on/off button and release the
safety button.
The blades pull the mini-tiller forward. By
holding back or pulling back the mini-tiller,
the blades will work into the ground. Make
sure that the mini-tiller does not work further
into the ground than its maximum working
depth.
The blades must always run at full speed. If
the speed of the blades decreases abruptly,
this is because the mini-tiller is overloaded.
If the blades are blocked by a foreign object
or if the mini-tiller is overloaded, a built-
in overload protection will automatically
switch off the motor. Once the mini-tiller has
cooled down for about 15 minutes, it can be
switched on again.
When you release the on/off button, it takes
about 2 seconds for the blades to fully stop.

Publicidad

Tabla de contenido
loading

Productos relacionados para Grouw 68141

Tabla de contenido