Connecting A Turntable; Connecting A Cd Recorder Or Md Recorder; Connecting The Antenna Terminals - Denon AVR-2106 Instrucciones De Operación

ENGLISH
Connecting Other Sources

Connecting a turntable

If humming or other noise is generated when the ground wire is connected, disconnect the ground
wire.
NOTE:
• The phono input can accept signals from moving magnet (MM) and high output moving coil
(MC) phono cartridges. If your turntable is equipped with a low output MC cartridge, you will
need to use a separate MC head amplifier or step-up MC transformer.

Connecting a CD recorder or MD recorder

If you wish to perform analog dubbing from a digital source, such as a CD or MD recorder to an
analog recorder such as a tape deck, you will need to connect the analog inputs and outputs as
shown below, in addition to the digital audio connections.
NOTE:
• Do not connect the output of the component connected to the OPTICAL 3 OUT terminal on
the AVR-2106's rear panel to any terminal other than the OPTICAL 3 IN terminal (
An F-type FM antenna cable plug can be connected directly to the unit.
Direction of broadcasting
station
Turntable
(MM cartridge)
A
AUDIO OUT
L
R
GND
2 AM loop antenna assembly
CD recorder /
MD recorder
AUDIO OUT
A
L
L L
R R
R
AUDIO IN
A
L
L L
R R
R
D
OPTICAL
OUT
D
OPTICAL
IN
page 36).
15
ENGLISH

Connecting the antenna terminals

AM loop antenna
(Supplied)
FM antenna
75 Ω/ohm
COAXIAL
cable
FM indoor
antenna
(Supplied)
AM outdoor antenna
Connect to the AM
antenna terminals.
1 2
3
Remove the vinyl tie
Bend in the reverse
and take out the
direction.
connection line.
4
a. Antenna placed on
a stable surface.
Mount
b. Hanging the
antenna on a wall.
Use the
installation hole to secure the antenna to a wall, etc.
Connecting Other Sources
NOTE:
• Do not connect two FM antennas
simultaneously.
• Even if an external AM antenna is used, do
not disconnect the AM loop antenna.
• Make sure the AM loop antenna lead
terminals do not touch metal parts of the
panel.
Ground
Connection of
AM antennas
1. Push the lever.
2. Insert the
conductor.
3. Return the lever.