Desktop Installation - KlipXtreme KMM-400 Instrucciones De Montaje

Label Image Item
G 5mm Phillips screw Allen wrench combination
M-A M4x12 screw
M-B M5x12 screw
M-C D5 metal flat washer
M8x60mm screw
M-D
IMPORTANT:
At least two qualified people should perform the assembly procedure. Personal injury and/or
property damage can result from dropping or mishandling the display.
Mounting surfaces must be sturdy and flat.
Do not install this product on a weak, uneven surface, prone to vibration or susceptible to
other movements. Reinforce the structure as necessary before installing the mount.
Supported monitor weight: 14.3lb
The combined weight of all components shall not exceed the rated load capacity of the
mounting arm.
2. WARNING!
• Prior to installing this product, you must read all instructions thoroughly. Keep these
installation instructions in an easily accessible location for future reference.
• Safety measures must be practiced at all times during the assembly of this product. Use
proper safety equipment and tools for the assembly procedure to prevent personal injury.
As the arm is under tension and may suddenly spring upwards, keep it
to their highest position when removing the monitor. Failure to do so
may cause personal injury and equipment damage.
• KlipXtreme does not warrant against damage caused by the use of any KlipXtreme mounts
for purposes other than those for which it was designed or damage caused by unauthorized
attachments or modifications, and is not responsible for any damages, claims, demands, suits,
actions or causes of action of whatever kind resulting from, arising out of or in any manner
relating to any such use, attachments or modifications.

3. Desktop installation

Quantity
Notes:
1
• The monitor mount allows two installation configurations. It may be clamped to a desk or
table, or mounted through a grommet hole. Instructions for both will be provided in the
4
following sections.
4
• First, decide where you prefer to place your monitor. Prior to attaching the mount to your
4
desk, make sure you have enough room to fit the entire assembly either behind or in the
cable hole area of your desk, depending on the mounting method you choose.
1
Option A: C-clamp installation
1. First, attach the grommet bracket (B) to the C-clamp mount base (C) using the supplied
two M6x8mm screws (E) and tight them firmly with the 5mm Phillips screw Allen wrench
combination.
2. The clamp provides two positions depending on the thickness of your desk (from 10 to 78mm).
3. For a C-clamp installation from 10-50mm use the top screw hole.
4. Slide the clamp base onto the edge of your desktop in your desired location.