KlipXtreme KMM-400 Instrucciones De Montaje página 4

Option B: Grommet installation
1. This option requires a hole through the mounting surface.
2. Center the grommet bracket (B) over the top of the hole in the mounting location and hold
it firmly in place. You may need some help to perform this installation.
3. From underneath the surface center the flat clamping plate with the grommet bracket.
4. Insert the (M-D) screw through the hole in the center of the clamping plate and the grommet
bracket, and tighten it firmly with the 5mm Phillips screw Allen wrench combination until both
pieces are securely fastened.
M-D
9. Installation of the monitor plate to the display
1. Hold the two halves of the spring arm firmly together and have someone else cutting off the
seal around them. Slowly release the spring arm and allow it to gradually stretch to its full
extension.
2. Attach the monitor mount assembly (A) to the clamp base tightening the small screw
located in the back and bottom end of the mount assembly pole until the mount holds
firmly in place.
3. To insert the screws, carefully place your display face down on a soft, even surface, and
identify the threaded mounting points that are located on the back panel.
Note: If a stand is attached to a monitor, it must be removed now.
Safety measures must be practiced at all times during the assembly of this product. At least
two qualified people should perform the assembly procedure. Personal injury and/or
property damage can result from dropping or mishandling the monitor.
4. Determine the correct screw size and mark the depth of the mounting point. Please note
that not all the hardware included will be used.
CAUTION: Verify the adequate thread engagement of the screw on your monitor. Too short
will not hold the display and too long will damage it.
Too Short
Note: It will be necessary to adjust the installation according to your monitor VESA configuration.
Correct Too Long