Publicidad
Chair for older children:
In this position the large board is used a seat and can be set in the positions 6-7-8-9-10. The
small board serves as a leg rest and can be set in the positions 1-2-3-4, depending on a child foot
position, or disassembled. Do not use the tray and the bow-shaped handle with safety belts in
this position.
D.يAssemblyيofيtheيbabyيhighchair
You will need the Allen wrench (12). Perform assembly on soft surface that will not damage
surface of elements.
Start from assembling the leg (1) with the cross-bar (4). Notice that there are protruding pins in
the cross-bar. Gently adjust the protruding element with the first orifice from the bottom. Look
at the figure I and adjust the cross-bar in the way enabling you to insert the cylinder nut (11)
into the orifice on the side element surface. Insert the bolt (13) into the orifice in the leg and
tighten it through the cross-bar into the nut. Pay attention that the bolt must match the nut.
Then use the Allen wrench (12) to tighten the bolt.
Repeat the aforesaid steps with the next cross-bar (4) by fixing it to the same leg (1). Tighten
another leg (2) to the structure consisting of two cross-bars and one leg. At this and subsequent
stages we suggest to leave the leg 2 slightly loosened in order to enable assembly of next
elements inside the chair. The emerging structure must look as shown at the figure II.
Tighten the oblong bar (3) with the bolts (10) to the emerging structure from both sides at leg
half-height. The structure shall be as shown as the figure IV.
Then gently insert the backrest (5) into the sockets located at the very top of the legs from their
inside. Vertically insert the rectangular nut (from the right side/ leg 1) (15) to the already
inserted backrest. Insert the bolt (9) into the orifice in the leg and then tighten through the
backrest into the nut (figure V). Pay attention that the bolt must match the nut. Repeat this step
at another side of the backrest, however remember not to tighten the bolt to leave play for
assembly of other elements. The figure VI shows the backrest fixed to the structure.
29
Publicidad
