Auto Setup - Denon AVR-2105 Instrucciones De Operación

ENGLISH
Before setting up the system
1
Refer to "CONNECTIONS" (pages 5 to 9) and check that all connections are correct.
2
Press the Power switch (button).
ON OFF
• ON
¢
The power turns on and indicator is light.
Set the power switch to this position to turn the power on and off from the
(Main unit)
included remote control unit.
• OFF
£
The power turns off and indicator is off.
In this position, the power cannot be turned on and off from the remote control
unit.
3
Turn on the power.
ON / STANDBY
Press the Power ON/STANDBY switch (button).
(Main unit) (Remote control unit)
4
Press the SYSTEM SETUP button to enter the
setting.
*SYSTEM SET UP
(Remote control unit)
NOTE: Please make sure the "AUDIO" position of
the slide switch on the remote control unit.
5
Press the ENTER or
(Remote control unit)
NOTE:
• Press the SYSTEM SETUP button again to finish system set up. System set up can be finished at any time.
The changes to the settings made up to that point are entered.
12
(down) button to switch to the Auto Setup.

Auto Setup

The Auto Setup function of this unit performs an analysis of the speaker system to permit an appropriate
automatic setting.
When performing Auto Setup, a microphone is required for the setup.
Measurement and setting details
2
q Speaker Config.: This sets the speaker connection mode, polarity, and bass reproduction ability.
w Delay Time
: This sets the optimum delay time from each speaker corresponding to the listening
position.
e Channel Level : This sets the volume that is output from each speaker.
NOTE:
• A loud test tone is output during the measurement. Please consider this should you be planning nighttime
measurements, and consider not allowing small children into the listening room at this time.
Connecting the microphone for Auto Setup
1
Connect the microphone for Auto Setup to the
Setup Mic connector on the front panel of the
unit.
SURROUND SELECT SELECT TONE
PHONES SPEAKER SURROUND 5CH / 7CH DIRECT /
BACK STANDARD STEREO STEREO MODE CONTROL
A B V.AUX INPUT
SURROUND TONE
PARAMETER DEFEAT
S-VIDEO VIDEO L AUDIO R OPTICAL SETUP MIC
AV SURROUND RECEIVER
2
Place the microphone for Auto Setup at the
actual listening position which will be at the
same height as your ears. Use a tripod or level
surface at positioning.
AVR-2105
Listening position