Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 9
PREPARE FOR CABINET MOUNTING
Mark the hole location at the back of the bottom panel
(Located underneath bottom panel).
STEP 11
SQUARE UP CABINET
Adjust the top of the unit left or right as needed to square the
door (bump either side next to the rail at top, back).
STEP 10
MOUNT CABINET TO WALL
Remove the unit from the rail and install the wall anchor (M) using a 5/16" drill bit, or
drill a 1/8" pilot-hole if a stud aligns with the location.
Place the unit back onto the rail and align the hole with the wall anchor (M) or pilot hole.
Install the anchor screw (N) into the wall anchor or pilot hole.
CAUTION: Do not over-tighten screws.
STEP 12
MOUNT CABINET TO WALL
Install the keeper-brackets (O) at the back of each side panel, right below the rail. Use
one keeper bracket screw (H) per side.
CAUTION: Do not over-tighten screws.
7
Publicidad
