How To Wire Your Ceiling Fan (D1) - Fanimation Distinction myFanimation A1 Serie Manual Del Propietário

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

To avoid possible electrical shock, be sure electricity

is turned off at the main fuse box before hanging

(Figure 1).

NOTE: If you are not sure if the outlet box is

grounded, contact a licensed electrician for advice, as

it must be grounded for safe operation.

1. Connect the green grounding lead from the

downrod/hanger ball assembly and the green

grounding lead from the hanger bracket to the supply

grounding conductor (this may be a bare wire or wire

with green colored insulation). Securely connect wires

with wire connector. Securely connect the white fan

motor wire to the white supply (neutral) wire using

wire connector. Securely connect the black fan motor

wire to the black supply wire using wire connector

(Figure 2).

NOTE: If you feel that you do not have enough electrical

wiring knowledge or experience, have your fan installed

by a licensed electrician.

WARNING

Check to see that all connections are tight, including

ground, and that no bare wire is visible at the wire

connectors except for the ground wire. Do not

operate fan until the blades are in place. Noise and

motor damage could result.

2. After connections have been made, turn leads

upward and carefully push leads into the outlet

box, with the white and green leads to one side

of the box and the black leads toward the other side.

The wires should be spread apart with the grounded

conductor and the equipment-grounding conductor on

one side of the outlet box and the ungrounded conductor

on the other side of the outlet box. (Figure 3)

3. Once the connection has been made, slide the

receiver into the hanger bracket, taking care not to

pinch the wires. (Figure 4)

All manuals and user guides at all-guides.com