LOWES Kobalt KEG 1040-03 Manual Del Usuario página 6

SAFETY INFORMATION
• Check Damaged Parts - Before further use of the product, a guard or other part that
is damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other condition that may affect its operation. A guard
or other part that is damaged should be properly repaired or replaced by an authorized
service center unless indicated elsewhere in this manual.
• Clear the area to be cut before each use. Remove all objects such as rocks, broken glass,
nails, wire, or string that can be thrown or become entangled in the cutting attachment.
• Always hold the edger firmly, with both hands on the handles, while operating. Wrap
your fingers and thumbs around the handles.
• Avoid Accidental Starting - Don't carry the edger with your finger on the trigger.
• Do not operate the edger in gaseous or explosive atmospheres. Motors in these
appliances normally spark, and the sparks might ignite fumes.
• Do not use the edger on or near graveled surfaces.
• Damage to edger - If you strike a foreign object with the edger, stop the tool immediately,
check for damage and have any damage repaired before further operation is attempted. Do
not operate with a broken guard or blade.
• Replace a cracked, damaged or worn-out blade immediately, even if damage is limited to
superficial cracks. Such attachments may shatter at high speed and cause serious or fatal injury.
• Do not charge the battery pack in rain, or in wet locations.
• Use only with the battery packs and chargers listed below:
BATTERY PACK
KB 240-03; KB 440-03; KB 640-03;
• Use Only with the 40V Lithium-Ion Power Head KMH 1040-03.
• Do not dispose of the battery in a fire. The cells may explode. Check with local codes for
possible special disposal instructions
• Do not open or mutilate the battery. Released electrolyte is corrosive and may cause
damage to the eyes or skin. It may be toxic if swallowed.
• Exercise care in handling batteries in order not to short the battery with conducting
materials such as rings, bracelets, and keys. The battery or conductor may overheat and
cause burns.
• Replacement Parts - When servicing, use only identical replacement parts. Use of any
other accessory or attachment may increase the risk of injury.
• Battery tools do not have to be plugged into an electrical outlet; therefore, they are
always in operating condition. Be aware of possible hazards even when the tool is not
operating. Take care when performing maintenance or service.
• Remove or disconnect battery pack before servicing, cleaning or removing material
from the product.
• Do not wash with a hose; avoid getting water in motor and electrical connections.
• Do not incinerate the appliance even if it is severely damaged. The batteries can
explode in a fire.
• Do not expose a battery pack or tool to fire or excessive temperature. Exposure to fire
or temperature above 212 °F (100°C) may cause explosion.
• If situations occur that are not covered in this manual, use care and good judgment.
Contact the Customer Service Center for assistance.
• Save these instructions. Refer to them frequently and use them to instruct others who may
use this tool. If you lend this tool to someone else, also lend these instructions to them to
prevent misuse of the product and possible injury.
NOTE: SEE OPERATOR'S MANUAL FOR YOUR KOBALT KMH 1040-03 POWER HEAD
FOR SPECIFIC SAFETY RULES.
CHARGER
KRC 840-03
6