Bellman & Symfon CARQ Manual Del Usuario página 75

Default signal pattern
When the door transmitter is activated by a microphone or a connected
doorbell, the following happens:
 The transmitter's LED lights up to show that it's signalling the receiver.
 The receiver's LED lights up and it starts to sound, flash or vibrate with a
certain pace, called signal pattern.
The transmitter and the connected accessories determine the signal pattern
and the default is as follows:
Transmitter Receiver signal pattern
Source LED LED
Internal microphone Green, top Green light
External microphone Green, bottom Green blinks
Connected doorbell Green, top 3 x green blinks
143
Sound Vibration Flash
1 x door chime, low Slow Yes
2 x door chime, high Slow Yes
1 x door chime, high Slow Yes
Changing the signal pattern
The transmitter controls the signal pattern. Open the trans-
mitter front cover and move the signal switches according
to the tables on page 145–148 to change it.
Note: Switch no. 4 is for electromagnetic detection. The
signal pattern may differ depending on the receivers.
Deleting the recorded sounds
To delete all recorded sounds, press and hold button 1 and 2 simultaneously
for 5 s. Note: All radio key settings and signal settings are kept intact.
Turning the internal microphone back on
Restart the transmitter by removing the batteries and putting them back
in. Within 2 minutes, press the lower button 10 times to turn the internal
microphone back on. The LEDs will blink 3 times in green to confirm.
On
Off
SIGNAL
144