KMR 3534 Datos Técnicos página 4

4 I English
1 TECHNICAL DATA
Type
Dimensions mm
Weight kg (without fasteners)
Single sequential or contact actuation
Recommended operating pressure
range
Maximun permissible operating
pressure
Air consumption per driving
operation
Magazine capacity No. of fasteners
Penetration depth setting
Fastener: Plastic bound nail
Nail length mm
Nail shank Ø mm
Recommended lubricant
1 litre special oil. Code No.
250 cm3 grasa especial. Code No.
2 NOISE / VIBRATION INFORMATION
Noise characteristic values *
A-weighted single-event emission
sound pressure level at work
station L pA, 1s
A-weighted sound power level
L WA, 1s, d
Vibration characteristic values **
Weighted r.m.s.-acceleration (a)
The noise level when working can exceed 85
dB (A). Wear ear protection!
* Measured values determined according to
EN 12549:1999.
** Measured values determined according to
ISO 8662-11:1999.
3 SUPPLIED WITH
1
Strip magazine Nailer
1
Tool use and safety instructions
1 Technical data sheet
KMR
4
3534
Only those fasteners specified under technical data
(see 1) may be used.
385/530
When filling the magazine, hold the tool so that the
4.4 kg
muzzle is not pointing towards own body or towards
any other person.
Do not load the tool with fasteners with the safety
5-8.5 bar/
yoke or trigger depressed.
0.5-0.85 MPa
Pull pusher back until it has reached the point where
8.5 bar/
there is noticeable resistance and it catches. Introduce
0.85 MPa
2 nail strips into the magazine, unlock pusher and lead
5.0 l at 6
it against the nail strip. Make sure that the nail strips
bar / 0.6 MPa
lie correctly in the magazine and that the pusher nose
reaches over the head of the last nail. Never should the
56-70
pusher be allowed to snap forward in a magazine
no
which is half or totally empty. Always guide it by hand
up to the nail strip or stop.
65-100
2.8-3.8
5
9 4420
The penetration depth of the nail head can be
68 3868
controlled by means of the air pressure. If this is not
satisfactory, the penetration setting offers a more
accurate adjustment of the penetration depth. The
penetration setting is adjusted by loosening the
screw (b) and moving the bottom part of the safety
3534
yoke (a) by one or more notches.
For safety reasons, this should only be carried out in
a depressurised state.
Tighten the screw again.
90 dB(A)
103 dB(A)
6
3.0 m/s2
Suspension
Balancer for 30-55 N (3.0-5.5 kp),
cable travel 2.0 m
FILLING THE MAGAZINE
SPECIAL VERSION: PENETRATION SETTING
USING THE SAFETY YOKE
ACCESSORIES
3534
Code No.
73 4894
28 6478