Tool Safety - TEXA TTC Manual

3.4 Tool Safety

The tool was designed for the use in specific environmental
conditions.
The use of the tool in environments with temperature and moisture
characteristics different from those specified may impair its
efficiency.
Safety Measures:
Place the tool in a dry place.
•
Don not expose or use the tool near heat sources.
•
• Position the tool making sure it can be properly ventilated.
Do not use corrosive chemicals, solvents or harsh detergents to clean the
•
tool.
The tool was designed so as to be mechanically tough and suitable
for use in a workshop.
Carelessness in the use and excessive mechanical stresses may
impair its efficiency.
Safety Measures:
Do not drop, shake or subject the tool to shocks.
•
Do not perform any kind of intervention that may damage the tool.
•
• Do not open or dismantle the tool.
The tool was designed so as to be electrically safe and to work
with specific power supply voltage levels.
Failure to comply with the specifications related to the power
supply may impair the tool efficiency.
Safety Measures:
• Do not wet with water or other liquids.
• The power supply of the tool must be always connected according to the
procedures shown in the present manual.
Never use external batteries to power the tool.
•
• While recharging from mains use only the battery charger that might be
supplied with the kit.
en
43