Faber BRIO GM A90 FB EXP Manual De Instrucciones página 10

USE
5 - SAFETY WARNINGS
It is most important that all the warnings shown in paragraph 3 of the Installation Instructions are
strictly observed. Moreover, pay special attention to the following warnings during the use and
maintenance of the cooker hood:
5.1 - The grease filters and charcoal filters should be cleaned or replaced as recommended by
the manufacturer or more frequently if the hood is used consistently (over 4 hours per day).
5.2 - When using a gas hob in connection with the cooker hood never leave the burners of the
hob uncovered while the hood is in use or when the pans have been removed. Switch off
the gas before removing the pan, or for just short periods and never leave the hob
unattended.
5.3 - Always ensure that the flame is kept at the correct intensity to prevent the flame from
licking round from the bottom of the pan; this will save energy and will avoid a dangerous
concentration of heat.
5.4 - Always ensure that the appliance is used in accordance with the manufacturer's
instructions for the removal of contaminated air and odours during cooking.
5.5 - To replace the mains cable, please contact your nearest After Sales Service.
6 - OPERATION
Control panel (fig. 10)
The cooker hood can be operated as follows:
SWITCH L = Controls the worktop illumination
SWITCH M = Controls the power to the motor
SWITCH V = Controls the fan speed:
Position 1 = Low speed, should be selected when simmering or using only
Position 2 = Medium speed, should be selected for normal cooking. This
Position 3 = Top speed, should be selected when frying or cooking food with
EN
one pan; the noise level is kept to the minimum.
speed offers the best ratio between air capacity and noise level.
strong odours, even for a long period.
10
1
10
0