Initial Operation; Troubleshooting - Apex Tool Group Cleco 936491PT Manual De Instrucciones

3

Initial operation

3 Initial operation
WARNING!
Risk of explosion if other batteries are used
Use only Cleco lithium ion batteries, order no. 936400PT or order no. 935377. Never use other battery

types.
NOTE
LED should not be flashing red before it is plugged in.
When charging is finished, the charger automatically shuts off the charging process. LED
nently in green.
4

Troubleshooting

Error
LED not lit despite function-
ing power supply
LED goes out when the
battery is plugged in
LED not lit up / not flashing
even though battery is plugged
in
LED flashes red
LED flashes red
20
All manuals and user guides at all-guides.com
EN EN EN
Cause
No power supply voltage.
Power cable defective.
Charger defective
Faulty charging electronics
No battery contact
Contacts are dirty.
Battery is damaged
Battery is damaged
The temperature in the battery is
too high or < 0°C (32 °F)
P2069BA/INT 2014-06
Connecting the charger to the power network:

LED is lit up green and indicates that power
is supplied.
Plug the battery into the charger and ensure

that it is securely connected.
LED is flashing green, indicating that char-
ging is in progress.
Measure
Check and restore the power

supply voltage.
Replace power cable.

Replace charger

Replace charger

Plug the battery in again

Clean the contacts of the

charger and battery
Check battery and replace if

necessary.
Check battery and replace if

necessary.
Remove battery from char-

ger and repeat charging after
approx. 10 min
is lit perma-
69b_1_5 en.fm, 16.03.2015