Solar Panel; External Power Supply - Num'axes PIE1060 Manual De Instrucciones

3.2.

Solar panel

Fully charge the lithium battery of the solar panel before using the
product. The built-in battery is the primary power source for the
camera.
The solar panel built-in battery can be charged with solar energy or with
the supplied USB cable.
The trail camera uses energy from the solar panel first before using energy from the batteries.
NOTE: the solar panel can't charge Ni-MH batteries installed in the battery compartment.
3.3.

External power supply

The device can also operate with an external power supply (5V/1A)
We recommend removing the AA batteries when an external power
supply is used.
4. Memory card
Using a memory card is required to operate the camera
(micro SD card | 256 GB maximum | U1 class 10 minimum).
You can purchase micro SD cards at any time at www.numaxes.com.
When the camera is in SETUP mode and no memory card is
inserted, the LDC screen displays "No card".
Formatting the memory card in the trail camera before using it for the first time is strongly
recommended, especially when the card has been used in other devices. A memory card formatted in
another device may not be compatible.
Before inserting or removing the memory card, the camera must be turned off (switch in the OFF
position). Failing to do so may cause loss of or damage the files already recorded on the memory card.
When the memory card is full, the LCD screen indicates "Memory full".
5. Buttons functions in SETUP mode (selector in SETUP position)
Press this button twice to enter the settings MENU.
Press this button once to start the REPLAY mode.
Allows you to take a photo or start recording a video and then stop it.
In this mode, the video length is not limited.
Allows you to activate or deactivate the Wi-Fi hotspot.
Allows you to check the charge level of the AA batteries.
Switch to Photo mode.
PIE1060 - Indice B – Mars 2022 19/88