Overheat Protection; Separating The Blade Attachment - ADE KA 2110 Instrucciones De Operación

5. Pull the blade attachment out of the glass container.
6. Take the ingredients out of the glass container.
Processing Tips
‚ To ensure that ingredients are chopped evenly, switch the device off after each
burst of chopping. Then use a rubber scraper to push the ingredients back into the
middle of the bowl. You can then switch the device back on again.
‚ You can also use the device in pulse mode by pressing the I or II button briefly.
When the blades stop turning, some of the food will fall back underneath them.
This helps to ensure even processing.
‚ In many cases, the chopper will get the job done in seconds. Avoid mixing for too
long in order to preserve the structure of the food.
‚ The processed food should either be consumed immediately, or used further as
required. The container is not intended to be used for permanent storage.

Overheat protection

The device has a built-in overheating protection. If the overheat protection triggers, the
device will switch off immediately during use.
In this case:
1. Release the power level button (I or II) and take the plug out of the power socket.
2. Let the device cool down for at least 30 minutes.
Eventually, you can use the device again as usual.

Separating the Blade Attachment

WARNING against injury
− The blades are very sharp - do not touch them with bare hands. If
the blade attachment is still clean, we recommend that you put the
protective covers onto the blades.
The blade attachment is formed of two sections. When the blade is very dirty, it is
useful to separate it in order to clean it.
Electric Mini Chopper KA 2110
Separating the Blade Attachment
25