Kinderkraft JULI Manual De Usuario página 27

WARNING! This product is suitable for a child who cannot sit
up unaided, roll over and cannot push itself up on its hands
and knees. Maximum weight of the child: 9 kg
The bassinet must not be used as a child carrier. The bassinet handle is only designed for assembly and disassembly on
the buggy frame.
Don't insert an extra mattress. The bassinet/seat comes with an integrated mattress.
The following applies to the buggy:
WARNING!
This seat unit is not suitable for children under 6 months
Always use the restraint system
The product is intended for children from 6 months old to 15 kg.
Applies to Kinderkraft car seat:
Kinderkraft JULI is available also in a set with a compatible Kinderkraft car seat.
The product is intended for children from birth to 13 kg.
If the seat is used together with the buggy, it does not replace a cradle or crib. For sleep, place the child in the bassinet,
cradle or crib.
I Buggy components
O. Frame
P. Front wheels x2
Q. Rear wheels x2
R. A set of wheel fasteners
4. Pin x2
5. Cap x2
6. Plug x2
S. Rear axle with brake
T. Safety bar
II UNFOLDING BUGGY FRAME
Place the frame (A) on a flat surface. Unlock the lock on the right side of the buggy (FIG. 1). Grasp the handle and lift the
frame up until you hear a sound, which indicates that the frame is properly secured (FIG. 2).
To mount the rear axle with the brake (E), put the rear free tips of the frame in the slots in the rear axle (FIG. 3) until you
hear the lock click. Make sure to properly protect them with snap fasteners (FIG. 4).
WARNING! After setting the frame in its natural position, the
brake lever should be on the side of the parent handle (FIG. 3.
III WHEEL ASSEMBLY/DISASSEMBLY
Put the rear wheel (C) on the protruding part of the rear axle (E). Press the plastic pin on the axle (D1), secure with the
plastic cap (D2) and cover the tip with a pin (D3). Each of the elements should be pressed with a slight resistance, until it
locks (FIG. 5 & 6). Repeat these steps on the other side of the buggy.
WARNING! When installed, the rear wheels cannot be removed.
In the case of exceptional necessity, it is possible to dismantle
the whole rear axle and wheels with brake after unlocking the
clips shown in Figure 4.
Insert the front wheels (B) into the slots in the front of the frame, until you hear the lock click (FIG. 7A).
The buggy has a system of swivel front wheels which can be locked in the straight-ahead position. To set the wheel in the
straight-ahead position, move the locking lever to the outside (FIG. 8). To unlock the wheel, move the lock lever to the
inside.
To remove the front wheel, press the button shown in Figure 9 and pull the wheel out.
U. Seat/bassinet 2 in 1
V. Bar under the bassinet/seat
W. Hood
X. Safety harness (factory-installed in the
bassinet/seat)
Y. Footmuff
Z. Car seat adapters (left and right)
AA. Rain cover
BB. Cup holder
27