KS Tools efuturo Instrucciones De Uso página 34

Opening the charging station
!
Attention
Damage to the device.
Damage to the device due to improper handling.
1. Remove the outer ring on the Wallbox.
2. Remove the screws on the front cover. Make sure that the screws do not get lost.
3. Lift the front cover and make sure that you do not damage any cables or cable connections on the inside.
Installation
Surface-mounted installation of the feeder cable
If the feeder cable or cable duct comes from below, the feeder cable to the Wallbox is introduced via the cable gland.
Flush-mounted installation of the feeder cable
When flush-mounted installation of the feeder cable, the positions must be set according to the drilling template.
Installation of the charging station on the wall
For installation on concrete, brick and wooden walls, use the enclosed mounting material.
If the substrate is different, a suitable type of mounting must be selected on-site. KS Tools GmbH recommends mounting
the charging station at a height of approx. 1.50 m above the finished floor (measured up to the top edge of the housing).
OPERATING INSTRUCTIONS
efuturo Wallbox
13