Ending The Charging Process - KS Tools efuturo Instrucciones De Uso

*For 3.
Mode
ON
Period within two minutes
after the start
Period within two minutes
after the start
Period within two minutes
after the start
OFF
The maximum available charging current depends on the following points:
• Connected load of the charging station
• Equipment/version of the charging station
• Current capacity of the charging cable
• Configuration of the DIP switches in the charging station

Ending the charging process

!
Attention
Damage to the charging cable.
Pulling on the cable can lead to cable breakage and other damage.
Only pull the charging cable out of the charging socket directly at the plug.
The charging process can be terminated prematurely on the vehicle. If you have the RFID version of the Wallbox, you
can also use the RFID card to stop the charging process.
If the cable is pulled out without first terminating the charging process, the Wallbox immediately switches off the charging
process.
Maintenance
!
Danger
Fatal injury hazard due to improper maintenance/repair.
There is a danger of fatal injury to persons carrying out work for which they have neither been qualified nor instructed.
• The device is only allowed to be maintained/repaired by persons who are familiar with it, have been informed about
the dangers and possess the necessary qualifications.
• Before maintenance/repair work is carried out, all safety conditions must be fulfilled.
!
Danger
Fatal shock hazard!
Components are live. Touching live parts will result in electric shock, burns or death. Observe the following points
before working on the electrical system:
• Disconnect the device from the power supply
• Secure against switching back on
• Check freedom from voltage
• Grounding and short circuiting
• Cover adjacent live parts and secure the danger zone
OPERATING INSTRUCTIONS
efuturo Wallbox
Hold RFID card against
sensor
Once
Start + once extra
Start + twice extra
Start + three times extra
repeated
Action LED display
Start Green
Setting for 1 h Blue once +
charging Green
Setting for 2 h Blue once +
charging Green
Setting for 3 h Blue once +
charging Green
Stop Blue light
Status
flashing Charging
Charging for 1 h
once
Charging for 2 h
twice
Charging for 3 h
three times
Standby
19