Schwinn Discover HYBRID Manual Del Proprietário página 39

Center the Brake Pads
❶ Insert a 1/32" spacer gage between the disc rotor and
brake pad. Figure 4.19
❷ Using a 2.5 mm Allen wrench, loosen the set screw.
❸ Using a 5 mm Allen wrench, turn the brake pad adjustment
screw to move the brake pad. Turning the pad clockwise
moves it towards the disc rotor, counterclockwise moves the
pad away from the disc rotor.
❹ Adjust the pad until the gap between the disc rotor and the
brake pads are even (1/32" per side).
❺ Re-tighten the set screw.
2
Set
screw
1/32 inch
clearance on
each side of
4
disc rotor
3
Brake pad
adjustment screw
Figure 4.19
Attaching the Brake Cable to the Brake Arm
❶ If the brake cable wire is not attached to the brake arm then
loosen the cable anchor bolt until you can see a gap large
enough for the brake cable wire. Figure 4.19
❷ Pull on the brake cable wire and place it under the cable
anchor bolt.
❸ Tighten the cable anchor bolt. Note: The brake cable should
not be "pulling" on the brake arm.
Adjustments 4
1
Brake
cable
wire
Brake arm
2
3
Cable anchor bolt
Figure 4.20
37
37