Remote Control; Inserting Batteries; Using The Remote Control Unit - Denon DCD-201SA Instrucciones De Operación

6

REMOTE CONTROL

The included remote control unit (RC-268) can be used to operate the DCD-201SA from a distance.
2

(1) Inserting Batteries

q Remove the remote control unit's cover.
w Insert two R6 (AA) batteries into the battery
compartment in the direction indicated by the marks.
e Set the cover back in its original position.
All manuals and user guides at all-guides.com
Cautions on Batteries
• Use R6 (AA) batteries in this remote control unit.
• Replace the batteries with new ones after
approximately 1 year, though this depends on the
frequency with which the remote control unit is
used.
• When replacing the batteries, wait about 2 minutes
after removing the old batteries before inserting the
new ones.
• Replace the batteries with new ones if the unit does
not operate when the remote control unit is
operated from nearby, even if the batteries are less
than a year old.
• Be sure to insert the batteries in the proper
direction, following the " < " and " > " marks in
the battery compartment.
• To avoid damage or leakage of battery fluid:
• Do not use a new battery with an old one.
• Do not use two different types of batteries.
• Do not short-circuit, take apart, heat or dispose of
batteries in flames.
• Remove the batteries when you do not plan to use
the remote control unit for an extended period of
time.
• If the battery fluid should leak, carefully wipe off the
fluid from the inside of the battery compartment,
then insert new batteries.

(2) Using the Remote Control Unit

Approx. 7m
30°
30°
• Point the remote control unit at the remote sensor as
shown on the diagram when operating it.
• When the DCD-201SA is connected in a system with
the 201SA series, the remote control signals for all the
system components are received at the remote sensor
of the pre-main amplifier (PMA-201SA).
NOTES:
• The remote control unit may be difficult to operate if the remote signal sensor is exposed to direct sunlight or
strong artificial light, or if there is an obstacle between the remote control unit and the remote signal sensor.
• Do not press buttons on the main unit and buttons on the remote control unit at the same time. Doing so may
result in malfunction.
ENGLISH
• The remote control unit can be used from a straight
distance of about 7 meters, but this distance will be
shorter if the there is an obstacle in the way or if the
remote control unit is not pointed directly at the remote
sensor.
• Use the remote control unit within a range of 30° to the
left and right of the remote sensor.
7