Additional Functions - GUTFELS COOL 3010 W Manual De Instrucciones

EN

10.3. Additional Functions

Timer
The timer function allows you to set the
desired operating time of the appliance
(in hours).
Set timer
1. Press the "TIMER" button (b) while
the appliance is in operation.
2. Set the desired time between 1 - 8
hours by pressing the "TIMER"
button (b) again.
→ The set time appears on the
display.
As soon as the set time has elapsed, the
appliance switches off automatically.
Or you can switch it off manually.
COOL
The appliance works as an air conditioner
in this operating mode.
3. When the fan is rotating, press the
"COOL" button (c).
→ The "COOL" control light lights up.
4. If the appliance does not detect any
water in the water tank within 10
seconds, a signal sounds and the
pump switches off. The 'COOL'
control light flashes for 20 seconds.
5. Press the "COOL" button (c).
→ The appliance stops operating and
the control light goes out.
OSC (LR/UD)
Adjust the rotation function for more
pleasant and better air circulation.
1. Press the "OSC (LR/UD) button to
activate the function.
→ The appliance starts rotating.
(LR = from left to right)
(UD = up and down)
2. Press the "OSC (LR/UD) button
again to deactivate rotation.
SPEED
1. Press the "SPEED" button (e).
→ The speed 01 > 02 > 03 is shown
on the display.
→ After 3 seconds, the ambient
temperature appears on the
display.
Page | 20
Filling the water tank
1. Switch off the appliance.
2. Remove the mains plug from the
plug socket.
3. Unscrew the water tank cap (10) on
the back of the appliance (bottom).
4. Pull out the water tank (5).
5. Fill the water tank (5) with clean
tap water.
✓ Make sure to fill the water tank (5)
only up to the marking.
6. Optionally, you can place a cooling
pack in the water tank (5) to
improve the "COOL" function.
7. Push the water tank (5) back into
the appliance.
8. Close the water tank cap (10)
again.
➢ Make sure that the water
in the tank is not lower
than the lowest mark,
otherwise the cooling
function cannot be
operated