Daily Maintenance; Clean The Dust Box; Clean The Rolling Brush - TCL Sweeva 6000 Manual

EN

Daily Maintenance

Clean the dust box

①
Empty the dust box, put the dust box close to the trash can,
and tap the dust box gently to knock off the excess dirt.
②
Disassemble the removed filter assembly, take out the
high-performance filter, and clean the filter with the
supplied cleaning brush.
③
The dust box and filter assembly can be thoroughly rinsed
with water as needed. (Note: The filter cannot be cleaned
with hot water or detergent.)
④
After cleaning, the dust box and filter assembly must be
thoroughly air-dried. (Note: Repeated washing will destroy
the material of the high-performance filter and make it
ineffective. Please clean it with caution.)
⑤
Reassemble the air-dried dust box and filter assembly, and
put it back into the robot vacuum.
If the wet dust box and filter assembly are put back into
*
the robot vacuum, it may cause damage to the main
machine or fan.
Clean the dust box

Clean the rolling brush

①
As shown in the figure below, press the buckle to take out
the protective cover, and take out the rolling brush
upwards.
②
Clean the rolling brush with a cleaning tool, and the blade
can cut off the hair entangled on the rolling brush.
③
Remove the spool at one end of the rolling brush and clean
away the hair entangled on it.
④
After cleaning, put the rolling brush back and make sure it
is installed in place.
2 2