Clean Up The Dust Channel; Replace The Dust Bag; Clean The Sensor - TCL Sweeva 6000 Manual

EN
Daily Maintenance

Clean up the dust channel

If the full dust icon on the screen of the self-emptying dustbin
flashes in red after replacing the dust bag, it is recommended
to unplug the power plug, reverse the self-emptying dustbin,
and check whether the dust channel is blocked by foreign
objects. If the dust channel is blocked, refer to the figure below,
use a screwdriver to remove the transparent cover of the dust
channel, and clean out foreign objects.
Note: Violent disassembly is prohibited. After cleaning, put it
back as it is.
Transparent cover of the dust channel
Dust channel

Replace the dust bag

When the dust bag is full, the full dust icon on the screen of the
self-emptying dustbin flashes in red or the APP gives a notice to
remind you to replace the dust bag in time. The green light and
white light of the dust collection icon flash when the dust bag is
in normal use.
Replace the dust bag
Open the Pull up the
top cover. handle of the
dust bag to
take out the
dust bag.

Clean the sensor

Please clean the sensor regularly, and wipe off the dust on the
sensor with a soft dry cloth or cleaning brush.
Recharging
sensor
Along-the-wall sensor
2 4
Install a new
Discard
dust bag
the old
and close the
dust bag.
top cover.
Anti-drop sensor
Recharging
sensor