Installation Instructions; Unpack The Air Conditioner; Prepare Air Conditioner For Installation - Haier ESA406K Manual De Uso Y Cuidado

Power Supply Cord
NOTE: Your air conditioner's device may differ from the one
shown.
A. Test button
B. Reset button
This room air conditioner is equipped with a power supply cord
required by UL. This power supply cord contains state-of-the-art
electronics that sense current leakage. If the cord is crushed, the
electronics detect current leakage and power will be
disconnected in a fraction of a second.

Unpack the Air Conditioner

Remove Packaging Materials
■ Remove and dispose of/recycle packaging materials. Remove
tape and glue residue from surfaces before turning on the air
conditioner. Rub a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm water and dry.
■ Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
■ Handle the air conditioner gently.
A
B

INSTALLATION INSTRUCTIONS

1. Place the top channel on the top of the air conditioner, lining up
2. Using four 13⁄32" screws, attach the top channel to the air
To test your power supply cord:
1. Plug power supply cord into a grounded 3 prong outlet.
2. Press RESET (on some devices, a green light will turn on).
3. Press TEST (listen for click; Reset button will trip, and on
some devices, a green light will turn off).
4. Press and release RESET (listen for click; Reset button will
latch, and on some devices, a green light will turn on). The
power supply cord is ready for operation.
NOTES:
■ The Reset button must be pushed in for proper operation.
■ The power supply cord must be replaced if it fails to trip when
the test button is pressed or fails to reset.
■ Do not use the power supply cord as an off/on switch.
■ A damaged power supply cord must be replaced with a new
power supply cord obtained from the product manufacturer
and must not be repaired.
■ The power supply cord contains no user serviceable parts.
Opening the tamper-resistant case voids all warranty and
performance claims.

Prepare Air Conditioner for Installation

Install Top Channel
the holes in the top channel with the holes in the top of the air
conditioner.
conditioner.
(For model ESA406K,ESA408K,ESA406K-L,ESA408K-L,
ESA406K-T,ESA408K-T,ESA408K-E three 13⁄32" screws is
needed to attach the top channel to the air conditioner. )
5