Removing The Cover - Kinderkraft MYWAY Manual De Uso

• Guide the vehicle's seat belt through both lap belt guides (G). Fasten the vehicle seat belt
and make sure you hear a "click".
• Adjust the headrest to the child's height (see section 4.2).
• Tighten the vehicle seat belt by pulling the first section of the hip belt, and then the
shoulder belt section.
Make sure that the hip belt is stretched as low as possible over the child's hips, placed in the
guides and fixed in the buckle. The shoulder belt should be positioned between the shoulder
and the neck of the child.
5.6 Removing the seat (ISOFIX fastening system)
• Press both sides of ISOFIX release button (H) on each side of the child seat. The attachments
are released and the colour of the markers turns red. Slide the ISOFIX arms back into the base
of the seat − while reversing the arms rattling can be heard.
6.1 Hiding the 5-point harness
• Release the buckle (Fig. 6.1a), to release the harness straps and move them to sides (Fig.
6.1b).
• Detach the shoulder pad latches (C), remove them from the harness straps (Fig. 6.1c)
• D. Slide the strap securing shoulder pads from the S-shaped metal buckle shape (Fig. 6.1d-
1) and pull down the left pad down (Fig. 6.1d-2).
• Lift the latches of the buckle inside storing compartments on both sides of the backrest
(Fig. 6.1e). The correct position of the straps is shown in Figure 6.1f.
• Remove the fabric from the front edge of the seat, in order to reach the fixing point of the
crotch strap. Detach the rubber bands and slide out the material around the harness
adjustment button. Pull out the crotch strap from T-shaped slot by twisting it, as shown in
Figure 6.1g.

6.2 Removing the cover

• Hide the harness and remove the cushions − if they are installed (see section 6.1).
• Detach Velcro tape sections of the cover located close to the lap belt guide (G). Remove
rubber bans securing the cover to the front edge of the seat.
• Starting from one side, carefully remove the cover from the edge of child seat body (Fig.
6.2a, 6.2b). Detach rubber bands securing the headrest cover, located close to the belt
guide (Fig. 6.2c) and the rubber band at the top of the headrest. Slide-off the cover from
the headrest.
6.3 Installing the cover and harness
• Adjust the child seat cover. Slide the crotch strap through the slot in the seat.
• Place the cover around the adjustment button (E), stretching it over the seat and backrest.
Attach rubber bans securing the cover to the front edge of the seat. Secure the cover by
sliding inside seat body slots.
• Put the cover on the headrest and secure it with rubber bands.
• Place the shoulder pads (C) on the harness straps.
• Check that the harness straps are not twisted.
49