Fuel Installation Plan - Briggs & Stratton 40689 Manual De Instalación Y Operación

Front Panel Removal and Installation (Figure 11):
1. Remove or attach the front panel, carefully, with the two
screws (A) that attach the panel to the unit.
11
2. If installed (for wind rated regions), remove or attach the
two screws (B, Figure 12) that attach the panel to the
base.
12
16
3. Lift and flex panel outward and off of the base. Use
caution to prevent damage to the battery box.

Fuel Installation Plan

WARNING
Propane and Natural Gas are extremely flammable and
explosive, which could cause burns, fire or explosion resulting
in death or serious injury.
• Installation must be performed by a licensed
professional.
• Install the fuel supply system according to NFPA 37 and
other applicable fuel-gas codes.
• Before placing the generator into service, the fuel
system lines must be properly purged and leak tested.
• NO leakage is permitted.
• DO NOT operate engine if smell of fuel is present.
WARNING
Propane and Natural Gas are extremely flammable and
explosive, which could cause burns, fire or explosion resulting
in death or serious injury.
• The generator is equipped with an automatic safety
gas fuel shut-off valve.
• DO NOT operate the equipment if the fuel shut-off valve
is missing or inoperative.
WARNING
Propane and Natural Gas are extremely flammable and
explosive, which could cause burns, fire or explosion resulting
in death or serious injury.
• LP gas is heavier than air and will settle in low areas.
• Natural gas is lighter than air and will collect in high
areas.
• The slightest spark could ignite these fuels and cause
an explosion.
• DO NOT light a cigarette or smoke.
TO THE INSTALLER: Consult with the generator owner(s)
and convey any technical considerations that can affect their
installation plans before applying these general guidelines.
The following general rules apply to gaseous fuel system
piping:
• The piping material must conform to federal and local
codes, be rigidly mounted, and be protected against
vibration.
• Piping should be protected from physical damage,
especially where it passes through flower beds, shrub
beds, and other cultivated areas where damage can
occur.
• Install the provided flexible fuel line (B, Figure 13)
between the generator fuel inlet port (A) and the rigid
BRIGGSandSTRATTON.COM