Maintenance And Inspection - MSW AG6 Manual De Instrucciones

OVERVIEW
MSW-AG6
F
E
G
I
C
D
A
B
H
A. housing
B. shield
C. Spindle
D. revolutions / torque adjustment
E. trigger
F. trigger lock
G. lubrication cap
H. flange
I. exhaust deflector
J. metal flange
K. Air intake
MSW-PAC3
C
I H
J
E
D
F G
A
A. housing
B. Air intake
C. disk shield
D. revolutions / torque adjustment
E. bolt
F. washer
G. flange
H. trigger
I. trigger lock
J. exhaust deflector
K. metal flange
MSW-MADG1/4K
C
E D
B
A
H
G
F
10
A. housing
B. Air intake
C. metal flange
D. trigger
E. trigger lock
J
F. flange
G. shield
H. spindle
K
DEVICE USE INSTRUCTIONS
OPERATION
1. Every time make sure the device disconnected from
source of compressed air.
2. Before use grease the device.
3. Unscrew the flange: grip the spindle with a spanner
and then use another spanner to grab the flange and
twist in an anticlockwise direction.
K
B
4. Insert the required tip.
5. Tighten the tip in the device: grip the spindle with
a spanner and then use another spanner to grab the
flange and twist in a clockwise direction.
6. Remove the air inlet cap and connect air hose to the
device.
Rev. 01.02.2022
7. To activate the device, release the trigger lock and
then press the trigger.
MSW-PAC3
Maximum disc diameter - 76 mm. The disc is not included
in set.
Before installing the grinding wheel:
• Inspect the condition of the grinding wheel.
• Check the outer appearance for evidence of damage,
cracks, scratches, chipping and any lost materials.
It is best to inspect in strong light. If any of the
mentioned damages occurs, using of the tool is
prohibited!
• Check the grinding wheel markings, especially the
specified maximum speed, against the speed of the
grinder.
• Install only the grinding wheels the maximum speed
is equal to or higher than the grinder spindle speed.
Never exceed the maximum speed specified on the
grinding wheel!
Install the grinding wheel with the compressed air isolated
from the tool!
Rev. 01.02.2022
EN
Having installed the grinding wheel, verify it is secured and
rotates freely by hand before starting the grinder. Make
sure that the grinding wheel does not snag against the
guard or any other component of the grinder.
AIR PREPARATION
For the pneumatic device to function properly, correct
preparation of the compressed air supplied to it is
necessary. Use of an air treatment unit is recommended. It
comprises an air dyer, regulator and a grease cup.
The compressor capacity should also match
consumption by the connected devices.

MAINTENANCE AND INSPECTION

1. Inspection of the machine.
Never use damaged tools. Inspect the machine, together
with its instrumentation, before each use.
2. Inspection of the mounting screws.
Regularly inspect all mounting screws and ensure that they
are properly tightened. Should any of the screws be loose,
retighten them immediately. Failure to do so could result
in serious hazards.
3. Device lubrication:
air
11