Blaser Flip Cover Manual De Instrucciones página 20

2. Open the clamping lever
assembly and remove the attached cover
mounting it.
3. Then guide the Blaser CM attachment assembly on to the
objective of your rifle scope up to the stop position.
The hinge of the Blaser Flip Cover is inserted into the recess
provided.
into the guide of the Blaser CM attachment assembly. See
illustration D.
4. Then close the clamping lever
5. Adjust the clamping force so that the clamping lever can be
closed and opened with the thumb (Fig. E).
• 1. To do this, please loosen the lock screw
turn using the hexagon socket key (size 1.5).
• 2. To increase or decrease the clamping force, close or
open the hexagon socket screw
• 3. Then hand-tighten the lock screw.
The Blaser CM attachment assembly is now mounted, adjusted
and ready to use.
20
D [1] and the cover of the Flip Cover is pushed
C [1] of the Blaser CM attachment
[1] to fully secure it.
C
E [1]].
C [2] before
E [2] by half a