Synchronizing The Cut Position When Using Different Paper Ways - Dascom Tally T2150S Guia De Instalacion

Cutter-en.book Seite 13 Donnerstag, 3. Mai 2007 9:42 09
Quick start guide
Synchronizing the cut position
when using different paper ways
ASCII80 ASCII136
Back Next
1 2 3
Paphand CX-bid
Back Next
1 2 3
Physlm Sync.Lab
Back Next
1 2 3
All manuals and user guides at all-guides.com
If you use different paper ways it is possible that minor divergences of the adjusted
cut position occur when switching between the paper ways. You can eliminate
these divergences from the adjusted cut position by means of the parameter
Sync.Lab in the test menu of the printer. In this case you have to use paper with a
black label on the back. This label is scanned after switching on the printer, when
changing paper and loading paper.
See section Technical data and Paper specifications for details about the position,
the dimensions and the density of the label.
To activate the parameter Sync.Lab, which is switched off by default, proceed as
follows:
First set to printer to test mode by pressing the Online key while switching on the
printer.
The display shows Test mode for about 1 second and then ASCII 80 ASCII 136.
Change to the parameter group Paphand by pressing the Next key (4) three times.
Online
4
Setup
Press the Paphand key (2).
Online
4
Setup
Press the Next key (4) several times until the Sync.Lab parameter appears in the
display.
Online
Press the Sync.Lab key (3).
4
Setup
Handling and settings
13