Spare Parts; Troubleshooting - Aqua Products SSDP37 Serie Manual Del Usuario

12

Spare Parts

The complete spare parts list and exploded view is available on the Aqua Products website:
AquaProducts.com
Contact an authorized service center to perform diagnostic tests or repairs not shown in general
maintenance.

Troubleshooting

The following provides some helpful hints for troubleshooting common issues when using the
cleaner.
Problem
Cleaner moving too slowly/
not sucking debris
All LEDs flashing on the
power supply
Floating cable is coiled or
tangled
Cleaner not sucking debris
Cleaner is stuck in the mid-
dle of the pool and is pump-
ing out water
Cleaner pattern stays in a
certain area of the pool
Cleaner does not cover
entire pool
Clean the filter bags.
•
Check to ensure the suction ports are not clogged or blocked.
•
Check if cleaner is turned on when out of the water.
•
Check the motor protection screen, filter bag may be stuck.
•
Check the propeller.
•
Restart the cleaner. Press On/Off button, cleaner will resume.
•
Lay the cable flat in the sun on the ground to straighten.
•
Change the order of the wheel axle pins.
•
Verify the floating cable enters the water near the middle of the pool
•
length. (TIP: mark the correct length with black electrical tape)
Reduce the amount of cable in the water.
•
Check cleaner is set up properly and turned on.
•
Make sure the filter bags are clean.
•
Check the propeller.
•
Adjust the suction ports under the cleaner for blockages.
•
Check for obstructions or any loose objects in the pool.
•
Check and adjust the height of the suction ports. They may be
•
touching the bottom of the pool.
Restart the cleaner at a different end of the pool.
•
Check for correct pool size setting: Large or Small.
•
Change the order of the wheel axle pins.
•
Clean the filter bags.
•
Adjust the cycle time setting.
•
Check the wheels and axles for blockages.
•
Change the order of the wheel axle pins.
•
Solution