Important Safety Instructions - Aqua Products SSDP37 Serie Manual Del Usuario

4

Important Safety Instructions

Congratulations on purchasing this Aqua Products Robotic Cleaner. Please read
through the entire manual before installing your new robotic pool cleaner. Your
cleaner must be installed and operated as specified.
Failure to comply with the following warnings can result in permanent injury, electrocution
or death.
PREVENT ELECTRICAL SHOCK
To reduce risk of electrical shock:
Connect unit to receptacle protected by a ground fault circuit interrupter (GFCI). Such a GFCI
•
receptacle should be provided by a qualified installer and should be tested on a routine basis.
To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button.
Power should be restored. If the GFCI fails to operate in this manner, the GFCI is defective. If the
GFCI interrupts power to the pump without the test button being pushed, a ground current is
flowing, indicating the possibility of an electric shock. Do not use this product. Disconnect the
cleaner and have the problem corrected by a qualified service representative before using.
Per the United States National Electrical Code
•
from the edge of the (pool/spa) water. In Canada, the Canadian Electrical Code (CEC) requires a
minimum distance of 3m (10 ft.) to be maintained between the pool edge and the control unit.
Never submerge the control unit.
Do not enter pool while the Aqua Products cleaner is in water.
•
Do not bury cord. Locate cord so as to prevent it from being damaged by lawn mowers, hedge
•
trimmers and other equipment.
To reduce the risk of electrical shock, do not use the Aqua Products robotic cleaner or control unit if
•
the cord is worn or damaged. Contact Fluidra Technical Support immediately for proper servicing
and replacement of the damaged cord.
Double insulation—For continued protection against possible electric shock, use only identical
•
replacement parts when servicing. Do not attempt repair of the Aqua Products robotic cleaner,
control unit, power cord, or floating cable.
NEVER OPEN CONTROL UNIT.
•
DO NOT USE AN EXTENSION CORD TO CONNECT THE UNIT TO ELECTRIC SUPPLY; PROVIDE
•
A PROPERLY LOCATED GFCI RECEPTACLE. THE CONTROL UNIT SHOULD BE PLUGGED INTO
THE GFCI RECEPTACLE BOX.
PREVENT ELECTRICAL SHOCK
To reduce the risk of injury, do not permit children to operate this product.
•
Do not let anyone, especially small children, sit, step, lean, or climb on any equipment installed as
•
part of your pool's operational system.
WARNING
(NEC ), keep the control unit at least five (5) feet
® ®