Cleaner Specifications; General Specifications; Connect To Power - Aqua Products SSDP37 Serie Manual Del Usuario

6

Cleaner Specifications

General Specifications

The general specifications for the cleaner are
as follows:
Control box
100-240 VAC, 50-60 Hz
supply voltage
Output voltage 30 V DC
Installed load 100 W max
When unpacking the cleaner and its
components:
Check cleaner and components for damage
•
during transport.
If there are any missing parts or damage,
•
contact Technical Support at 1-800-221-1750

Connect to Power

WARNING
Failure to comply with the following warnings
•
can result in permanent injury, electrocution
or drowning.
Prevent Electrical Shock
•
U.S.: Per NEC requirements, keep the
®
•
control unit at least five (5) ft. (1.5 m) from
the edge of the pool. CANADA: Per CEC
requirements, keep the control unit at least
three (3)m (10 ft.) from the edge of the pool.
Only connect the control unit to a
•
receptacle protected by a ground fault
circuit interrupter (GFCI). Contact a certified
electrician if you cannot verify that the
receptacle is protected by a GFCI.
Do not use an extension cord to connect the
•
control unit.
Do not allow anyone to swim while the
•
cleaner is in the pool.
The control unit is not waterproof. In order to
•
prevent electrocution, never submerge the
control unit or leave exposed to inclement
weather.
1. Plug power supply into a GFCI outlet
(Ground Fault Circuit Interrupter)
(Figure 1). Power Supply must be 5 ft.
from the pool's edge.
Figure 1. Plug into Power Supply
2. Straighten the floating cable. Lift the
flap on the power supply and plug in
the power cable (Figure 2).
Figure 2. Connect the Power Cable