Assembly; To Assemble The Handle; To Adjust The Handle Height - Husqvarna LC 142i Manual De Uso

Wait at minimum 5 seconds before you start the
maintenance.
• Only do the maintenance work written in this
operator's manual. More extensive work and
professional repairs must be done by an approved
service agent. Speak to your nearest service agent
for more information.
• Do the maintenance work correctly to increase the
lifetime of the product and decrease the risk of
accidents.
• Replace damaged, worn or broken parts. Always use
original spare parts from the manufacturer. Other
spare parts can cause damage to the product and
increase the risk of accidents.
• To prevent injury, do not remove or do modifications
to safety devices.
Introduction
WARNING:
product, read the safety chapter.
WARNING:
during assembly, turn the safety key to 0,
remove the battery and wait at minimum 5
seconds.

To assemble the handle

1. Align the holes in the handlebar with the holes in the
lower handle and attach the screws, cable clips and
knobs. Tighten the knobs fully.
1692 - 003 - 15.12.2021

Assembly

Before you assemble the
To prevent accidental start
• Put on heavy duty gloves when you use the cutting
equipment. The blade is very sharp and cuts can
easily occur.
• Keep the cutting edges sharp and clean for the best
and safest performance.
• Let your service agent regularly examine the product
and make necessary adjustments and repairs.
• Obey the instructions for how to change accessories.
Only use accessories from the manufacturer.
• When not in operation, keep the product, battery and
battery charger apart in a dry, indoor and locked
area. Make sure that children and persons that are
not approved cannot get access to the product,
battery or battery charger.
2. Attach the cables to the handle with the cable clips.
Note:
Make sure that there is not too much
tension in the cables. Too much tension can cause
damage to the cable if the handle is folded into
transport position.

To adjust the handle height

1. Loosen the lower knobs.
2. Remove the knob, washer, and screw on the left and
the right side.
9