Description Of The Machine; Machine Parts And Labels; Optional Kits; Accessories - Nilfisk S2 Instrucciones De Uso

Description of the machine

Machine Parts and Labels

Figure 1
1.
Identification plate:
code, serial number, EC marking, year of manufacture,
weight (kg)
2. Dust container
3. Dust container release lever
4.
Vacuum inlet
5. Plug for closing the side container
6. Accessories compartment
7. Warning label for Class L - M - H vacuum cleaners.
8.
Air outlet
9. Warning plate
the operator's attention to the fact that the filter must be
shaken only when the machine is off (see par. "Shaking
the primary filter" as well).
This machine creates a strong air flow which is drawn in through
the vacuum inlet and blows out through the outlet.
Before turning on the machine, fit the vacuum hose into the
inlet and then fit the required tool on to the end part (refer to the
manufacturer's accessory catalogue or Service Centre).
The diameters of the authorized hoses are indicated in the
Technical data table.
The machine is equipped with a primary filter which enables it
to be used for the majority of applications.
In addition to the primary filter that retains the most common
dust, a secondary filter (absolute filter) can be installed.
This machine is equipped with an internal baffle plate which
subjects the vacuumed substances to a circular centrifugal
movement that makes them drop into the container.
Figure 2
Vacuum cleaners for dust harmful to health are classified
according to different dust classification, in compliance with
standard EN 60335-2-69 – Annexe AA:
1. Class L label
2. Class M label
3. Class H label
The class H label reads the following.
CAUTION!
This vacuum
hazardous for the health.
Only authorised personnel wearing suitable
personal protective equipment should empty
and service the machine, including removing the
means used to vacuum the dust. Do not use without
the complete filter system in place.
Model
Draws
cleaner contains dust

Optional kits

Various optional kits are available for converting the machine.
On request, the machine can be supplied with optional kits
already installed. However, they can also be installed at a later
date.
Please contact the sales network for further details.
Instructions describing how to fit the optional kits and the
relative operation and maintenance manuals are supplied
together with the optional kits.
CAUTION!
Use only supplied and authorised genuine spare parts.

Accessories

Various accessories are available; refer to the manufacturer's
accessory catalogue.
CAUTION!
Use only genuine accessories supplied and authorised
by the manufacturer.

Packing and unpacking

All the dispatched equipment has been thoroughly checked
before being delivered to the haulage contractor.
On arrival, check the machine to see that it has not been
damaged during transport. In case of damage, immediately
lodge a complaint with the haulage contractor.
Dispose of the packing materials in compliance with the laws
in force.
Model A (mm)
S2 /S3 40L 700
S2 / S3 50L 700
S2 / S3 100L 700
S2 / S3 LP M/H
700
(*) Weight with packing

Unpacking, moving, use and storage

To unpack the vacuum unit, remove the retainers with a
hammer and a screwdriver.
Also remove the fastening devices placed by the manufacturer
when packing, by using suitable tools.
5
S2 - S3
Figure 3
B (mm) C (mm) kg (*)
860 1,350
860 1,750
860 1,750
860 1,750
GB
80
86
89
91
C343