Assembly And Installation - LIVARNO home 1002-W Instrucciones De Uso Y De Seguridad

suffocate on them�
Do not use the product if you notice any
„
damage�
Once the lamp has reached its end of life,
„
it must be disposed of in accordance with
local disposal regulations�
The LEDs are non-replaceable�
„
RISK OF ELECTRIC SHOCK! Incorrect
„
electrical installation or a power supply
voltage that is too high can potentially
cause electric shocks�
Installing this product involves working on
„
the mains electricity supply so it may only
be carried out by a competent person
according to the national regulations for
installation and connection in the country of
use�
Never tamper with or modify the product�
„
If the product has any identifiable faults,
„
stop using it immediately�
Do not open up the casing and only have
„
the product repaired by qualified
professionals� To that end you should
contact a specialist repairer� No liability or
warranty claims are accepted in cases
where repairs have been carried out by
unauthorised persons or the product has
been incorrectly wired or used�
The manufacturer/distributor of this product
„
accepts no responsibility whatsoever for
personal injury or damage resulting from
incorrect installation or use�
Do not exceed the specified mains voltage
„
(see "Technical data")�
Do not immerse the product in water or any
„
other liquids�
Keep the product away from naked flames
„
and hot surfaces�
Install the product in a position where it will
„
be protected from rain�
Before starting installation, cleaning or
„
maintenance work or if ever a fault occurs,
remove the mains fuse or switch off the
circuit-breaker for the circuit� Use a voltage
tester to check that the product is isolated
from the power supply�
34
GB/MT
RISK OF INJURY! Incorrect handling of
„
the product may potentially result in
personal injury�
Any protective cover that is split or cracked
„
must be replaced�
Never look directly into the light source�
„
Never point the light into the eyes of other
„
people or animals�
PLEASE NOTE! Incorrect handling of the
„
light may lead to damage to the product�
Check the screw fixings at regular intervals.
z Assembly and installation
Please note: remove the product from its
packaging�
Check that all package contents are
„
present�
Check whether the outdoor spotlight or
„
individual parts are damaged� If that is the
case, do not use the outdoor spotlight�
Please contact the retailer via the service
address indicated on the warranty card�
Choosing the installation position
Fix the outdoor spotlight at a height of 2-3m
„
to a sturdy wall that is not subject to
vibration�
Only install the outdoor spotlight outside of
„
the hand-contact zone so as to prevent it
being touched�
Position it at least 20cm away from other
„
objects so as to ensure good ventilation�
If possible, mount the outdoor security in a
„
position where it will not be exposed to dirt
or dust and is protected from rain (e�g�
under a roof overhang), sun and other
weathering effects�
Take care to ensure that the outdoor
„
spotlight is not affected by interference from
another light source�
Do not point the motion sensor
„
heating fans, air conditioning units,
swimming pools or other objects with
rapidly changing temperatures�
towards
2