Uline H-9635 Manual Del Usuario página 2

1. Place front, back and side panels upright. Align all
panels. (See Figure 1)
NOTE: Panels will be upside down for first part
of assembly.
2. Using a 16 mm wrench, attach side panels to front
and back panels at each corner, inserting one
M10 x 90 mm bolt and one M10 flat washer into
threaded nuts. (See Figure 1)
NOTE: Do not fully tighten bolts.
Figure 1
3. Insert feet into side panels at desired height.
Using a 16 mm wrench, attach feet to side, front and
back panels with two M10 x 90 mm bolts and two
M10 flat washers per corner. (See Figure 2)
NOTE: Top adds approximately 2" to total height
of unit.
Figure 2
PAGE 2 OF 24
ASSEMBLY
4. Flip workbench upright and tighten all bolts with a
16mm wrench.
5. Center shelf has three height options. Choose
preferred height. Using a 10 mm wrench, attach
back panel shelf mount to back panel on each
end by inserting one M6 x 15 mm hex bolt and one
M6 flat washer into threaded nut. (See Figure 3)
NOTE: Do not install front panel shelf mount.
Figure 3
6. Carefully place and center tabletop onto workstation.
Using the upright mounting plate holes as a template,
drill pilot holes into tabletop about 1/2" to 3/4" deep
with a 3/16" drill bit.
NOTE: These holes are drilled to allow mounting
of uprights in the following steps.
7. Remove top from workstation and flip upside down.
Using a 1/4" drill bit, drill eight holes completely
through tabletop in previously drilled pilot hole
locations. (See Figure 4)
Figure 4
Front
Back Panel
Shelf Mount
Upright
Mounting
Plate Holes
Drill completely
through pilot holes
0322 IH-9635