Rupes HR81M Manual De Instruccion página 9

ACCESSORY ASSEMBLY 291.390
Push the shaft-locking button (6) (Fig. 1) and screw the extention on a tool shaft (Fig.13).
Use only the accessories listed:
• 9.BF3030 – Nylon brush hard
• 9.BF3015 – Nylon brush soft
• 9.BF3000 – Horsehair brush
• 997.001 – Sanding backing Pad ø30
• 995.001 – Polishing backing Pad ø30
BUFFER PAD (Not provided)
CAUTION: Accessories must be rated for at least the speed recommended on the tool-warning
label. Accessories running over rated speed can fl y apart and cause injury. Accessory ratings must
always be above tool speed as shown on tool nameplate.
Assemble the buffer pad (3) (Fig. 7) on the velcro surface of the disc pad (4). Press the buffer pad to attach it to
the disc pad.
BATTERY PACK (PROVIDED OR OPTIONAL)
WARNING: Avoid short circuiting the contacts. Avoid mechanical damage of the battery pack. Do
not open or disassemble. Advice on protection against fi re and explosion. Keep away from open
fl ames, hot surfaces and sources of ignition.
Temperature in excess of 45°C reduce the performance of the battery pack. Avoid extended exposure to heat
or sunshine. Storage at room temperature (approx. 20°C) at approx. 20~60% of the nominal capacity. Every six
months of storage, charge the battery pack as normal.
Intended use
The battery pack 9HB120LT (Fig. 9) is used as the power source for Rupes BIGFOOT NANO Hybrid tool
HR81M/HR81ML.
Battery pack 9HB120LT specifi cations
WARNING: for technical data refer to the label of Battery pack 9HB120LT
WARNING: to reduce the risk of injury or explosion, never burn or incinerate a tool's battery pack even
if it is damaged, dead or completely discharged. When burned, toxic fumes and materials are created.
Model Chemistry
9HB120LT Lithium Ion
WARNING: charge Rupes Li-ION Battery pack 9HB120LT only in the Rupes Li-ION Battery Charger
9HC120LT. Other types of batteries may cause personal injury and damage.
This tool's battery pack and charger are not compatible with NiCd or NiMH systems.
When to charge
Charge your battery tool when convenient for you and your job. The Rupes BIGFOOT NANO Hybrid tool
Battery pack does not develop "memory" when charged after only a partial discharge. It is not necessary to run
down the battery tool pack before placing it on the charger. Use the led Battery pack 9HB120LT lever indication
on the Rupes BIGFOOT NANO Hybrid tool HR81M/HR81ML to determine when to charge the Rupes Battery
pack.
Charge the battery pack 9HB120LT (8)
The battery pack(s) contained in the kit shall be charger before use. The provided battery is charged <30%. In
order to charge connect the Li-ion battery with a charging station 9HC120LT till the charging is completed.
WARNING
For your personal safety, READ and UNDERSTAND the instruction manual of charging station
9HC120LT before using.
Assemble battery pack 9HB120LT
WARNING: Before (dis)assembling the tool assure that the speed regulation Knob (2) is in OFF
position.
Voltage (V) Capacity (Ah)
10.8 2.0
Energy (Wh) Weight (kg)
21.6 0.183 ±0.005
9