Pod Assembly Mounting - Kicker KSMT25 Manual Del Propietário

Pod Assembly Mounting

The KICKER KSMT25 Dual Pods allow for a custom
installation with directional aiming in nearly any
location or application. You will need access to both
sides of the mounting hole, as this will be used to
both route the wiring and mount the speaker pod
assembly. Custom mounting locations require more
preparation and work. Make sure that the pods
will not interfere with trunk and door opening and
closing mechanisms and that the Mounting Bolt
will not puncture wiring, or interfere with any other
mechanical parts on the underside of the mounting
surface. Cycle the windows all the way down and
up. Avoid structural metal and braces. Once you
have determined the placement of the Dual Pods
and wiring route, drill a hole into the mounting surface
using a 9/16" (15mm) bit.
Pod Mounting
1. Place the Washer over the Mounting Bolt.
2. Insert the Mounting Bolt into the mounting hole,
bringing the Washer and Pod flush with the mounting
surface.
3. Screw the Wing Nut to the bottom of the Mounting
Bolt from the other side of the mounting hole.
4. Make sure the speaker pod assembly does not
move back and forth or up and down.
English 9