Descargar Imprimir esta página

DoorBird D21 Serie Manual De Instalación página 13

Ocultar thumbs Ver también para D21 Serie:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

CHANGING THE LABEL OF A CALL BUTTON
NAMEPLATE
Applies only to devices with 1 and more illuminated
call buttons with nameplate.
Engraving Service
Engraving service for a modern and clean
appearance: www.doorbird.com/engraving
Please follow STEP 1 to switch off power.
We recommend to use a thin slot screwdriver
to remove the cover of the nameplate. We
recommend to use white paper for the label
which does not absorb moisture.
CHANGING THE LABEL OF THE INFO
MODULE
Applies only to devices with Info Module.
Please follow STEP 1 to switch off power and STEP 2
to open the device. You can then change the labeling
of the Info Module in the inside. We recommend to
use white paper for the label which does not absorb
moisture.
CONNECTING CALL BUTTONS TO THE
MULTI TENANT MODULE
Applies only to devices with 2 and more
illuminated call buttons with nameplate.
Connect only call buttons to the Multi Tenant Module
(e.g. Multi Tenant Module MTM18A) certified by Bird
Home Automation.
18
17
16
15
14
12
11
10
9
8
6
5
4
3
2
= 1. call
1
button jack
13
= 18. call
18
button jack
7
1
MAINTENANCE FOR DOORBIRD PRODUCTS
Cleaning and maintenance instructions
All DoorBird door stations are made of high-quality
materials and are designed for a durable lifetime.
Since door stations are usually installed in unprotected
outdoor areas, they are exposed to adverse weather
conditions and aggressive substances, especially close
to frequently used roads, in coastal and industrial
areas. Therefore please consider the following care
instructions. Unfortunately, we cannot accept any
liability for damage if these instructions are not being
observed.
Aggressive dirt such as bird droppings should be
removed as quickly as possible.
Never use abrasive detergents such as steel
NOTI CE
wool or scouring milk!
Warm water is usually sufficient, if necessary with
a little detergent, a soft cloth or brush. Plastic parts
(camera or name tags) must not be treated with
metal care products. Remove all residues of cleaning
agents or lubricants to avoid stains or discolouration
after the maintenance.
Stainless Steel
Only high-quality German stainless steel is used for all
available DoorBird door stations. However, high-quality
stainless steel can also rust, as approx. 70 % of stainless
steel is made of iron. Rust resistance is only achieved
by a protective layer (also called passive layer), which
covers the iron like a skin. This protective layer consists
essentially of chromium and other precious metals.
Iron particles, grinding dust and chips deposited on
stainless steel can lead to corrosion (rust film). These
iron particles can be found everywhere, but especially
in coastal and industrial areas and close to frequently
used roads. Please remove ferrous deposits immediately,
as they will attack your door station and lead to real
rust if not removed. To remove rust, simply wipe off the
dust; in addition, a care product is recommended, e.g.
WD 40, available e.g. at Amazon for less than € 5.00.
Simply apply in a thin layer and rub in. The same applies
if rust appears on the engravings on the stainless steel
surface.
Cement or lime splashes should be carefully removed
as soon as possible with a wooden spatula before
hardening.
The following cleaning detergents are not to be used
as they reduce corrosion resistance:
products containing chloride and hydrochloric
acid
Bleach (in case of accidental use, rinse thoroughly
with water)
Silver polish
13

Publicidad

loading