Installation; Overload Protection - Eco-Flo SUP55PC Manual Del Propietário

INSTALLATION

Do not work on pump until
power is unplugged.
Do not cut off ground pin or
use an adapter fitting.
1. The following may cause injury and/or severe
damage to pump and will void the warranty.
(a) Using an extension cord.
(b) Cutting off the ground pin or using an
adapter fitting.
(c) Working on pump or switch while
plugged in.
(d) Removing motor housing, unscrewing
impeller, or otherwise removing
impeller seal.
(e) Running the pump continuously.
(f) Pumping chemicals or corrosive liquids.
(g) Pumping gasoline or other flammable
liquids
2. Install garden hose to pump discharge adapter.
3. Position pump on pool cover. Pump position
can be adjusted using hose.
Do not pull pump by
power cord.
4. Plug cord into GFCI outlet.
5. If pump detects enough water depth,
pumping will begin automatically when
water is lowered to lowest pumping level.
The pump will not run dry.
6. Pump must be regularly cleaned to maintain
proper operation.
ELECTRICAL WIRE CONNECTION
Verify that the voltage and
frequency of the pump shown
on the nameplate corresponds to those available on
the mains. The installer must make sure that the
electric system is grounded in accordance with code.
• The plug and connection should be protected
from water splashes. Before using the pump,
always inspect it visually (especially power cable
and plug)
• Do not use pump if it is damaged
• If the pump is damaged, have it inspected by an
authorized service center.
• Make sure that electric connections are protected
from flooding. Protect the plug and the power
cable from heat or sharp edges.

OVERLOAD PROTECTION

This pump series has a built in thermal protection
switch. The pump stops if an overload condition
occurs. The motor restarts automatically after it
has cooled down. If it doesn't start automatically,
unplug the pump and plug it back in.
3