Before Use; Cleaning And Maintenance - cecotec BAMBA PRECISIONCARE PROCLIPPER TITANIUM Manual De Instrucciones

EN

3. BEFORE USE

• Take the product out of the box.
• Remove all packaging materials. Keep the original box.
• Make sure all the components are included and in good conditions,
otherwise, contact immediately the official Technical Support
Service of Cecotec.
• Oil the device's blades before the first use.
4. OPERATION
• Connect the device to a power supply.
• Turn on the clipper with the on/off switch.
Note: An audible click may sometimes be heard when switching
the equipment on, it is a result of the drive unit switching on. This is
completely normal.
How to adjust the blade fixing screw
The blades are fixed to the optimum position during manufacturing.
Despite this, it can be modified due to voltage fluctuations. Use the
blade fixing screw to reposition the blades at the desired position if
necessary.
1. Switch the clipper on.
2. Turn the adjustment screw clockwise until you hear a noise.
3. Turn the adjustment screw anticlockwise until the noise stops.
That is the optimum position.
How to change or readjust the blades
1. Turn off and disconnect the appliance from the power supply.
2. Undo both screws on the cutting unit, remove the bottom and top
blade.
3. When assembling them back, both should be aligned. Ensure:
• Adjust the blade lever to the shortest cutting length.
• The distance between the front edge of the bottom blade and the
front edge of the top blade should be between 0.8 mm and 1.5 mm.
44
• The bottom and top blade should be positioned parallel to each
other.
4. The first tooth of the top blade (from the left) must cover the first
tooth of the bottom blade.
5. The top-right tooth of the top blade must touch the top-right
large tooth of the bottom blade.
6. Tighten both screws.
How to adjust the cutting length
1. Blade lever:
The cutting length can be adjusted through the blade lever during
operation or before the appliance is switched on.
Lift the lever for shorter haircuts, or push it down for longer-length
haircuts.
2. Clip-on guide comb:
Depending on the type of haircut, the clipper can be operated with or
without the comb attachment.
Place the attachment comb onto the cutting edge of the cutting set and
press it down onto the cutting set until it clicks into position.

5. CLEANING AND MAINTENANCE

• Turn off and disconnect the device from the mains supply before
cleaning, assembling or disassembling any of its parts.
• Do not use compressed air, abrasive scouring pads, powders or
cleaners to clean the product.
• Do not immerse the appliance's body in water or any other liquid,
or place it under running water.
• Clean the clipper and the attachments after each use.
• When any of the parts of the device are washed, dry them
thoroughly before storing or using them again.
• Do not wrap the cord around the device to store it.
EN
45