Iluminarc LOGIC AR111 DN M Guía De Referencia Rápida página 5

Hi-Hat Preparation
The LOGIC AR111 DN M comes with a hi-hat bracket for mounting in a hi-hat can. Before mounting this product in a hi-
hat can, read the Safety
1. Remove the AC power wiring from the junction box completely, and use a flat-head screwdriver or pliers to
remove a knockout for the CAT6 cables.
2. Route 2 unterminated CAT6 cables through the knockout and cable pipe and terminate them with RJ45 plugs on
the other end.
The diameter of cable pipes in hi-hats requires a smaller diameter CAT6 cable, such as Monoprice
Slimrun CAT6 Ethernet patch cables, stranded 550 MHz, UTP, pure bare copper wire, 28 AWG.
3. Remove the bracket which comes with the hi-hat, keeping any wingnuts for the next step.
4. Install the hi-hat bracket which came with the LOGIC AR111 DN M with the wingnut(s) from the previous step
This bracket is designed to replace the bracket which comes with the hi-hat.
Press down on the tab
to open the side panel
of the junction box
Obey all local codes and regulations when installing hi-hats and wiring overhead.
LOGIC AR111 DN M QRG Rev. 4
QUICK REFERENCE GUIDE
Notes.
Cable pipe Knockouts
Pull CAT6 cables through
here and terminate with
RJ45 plugs
LOGIC AR111 DN M
hi-hat bracket
EN
Wingnuts
4