Step 6
Separate the LONG EXTENSION SLIDES (BB) from the LONG EXTENSION RAILS (AA) as shown in the upper
å
diagram. Be prepared, the parts are greasy.
Fasten the LONG EXTENSION RAILS (AA) to the UPRIGHTS (I and J). Use six SMALL 1/2" PAN HEAD SCREWS (24).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other two holes that line up with the holes in the UPRIGHTS. Turn a
SCREW into these holes.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Use these holes to fasten the EXTENSION
RAIL to the UPRIGHTS.
Open end
Page 10
AA
Push the black lever down and pull the SLIDE from the RAIL.
AA
J
www.sauder.com
BB
AA
I
SMALL 1/2" PAN HEAD SCREW
(6 used in this step)
Open end
24
420494