Troubleshooting; Additional Information - Rehau EVERLOC+ Manual De Instrucciones Del Producto

10. TROUBLESHOOTING

Observation Cause
Motor does not run Tool/battery contacts dirty
Tool/battery contacts damaged
Battery not correctly locked into the tool
Battery empty
Battery malfunction
Tool malfunction
Tool loses oil Leak in oil tank or release valve
Tool does not reach Leak in oil tank or release valve
initial pressure
Air in the hydraulic system
Tool malfunction

11. ADDITIONAL INFORMATION

For Professional Use Only
Proper preparation and installation is the responsibility of the installing
contractor. Only trained personnel should operate this tool. Persons using the
EVERLOC+ power tool must be experienced and appropriately licensed
professional contractors who understand the principles and practices
associated with the proper installation of hot- and cold-water potable and
hydronic systems.
Battery and Charger
For use only with DEWALT DCB127 battery. Charge only with the chargers
specified by DEWALT. Read and follow all safety warnings and instructions in
the product information accompanying the battery and charger.
Engineering Changes
Because REHAU believes in the continual improvement of its products,
engineering changes are made from time to time. Therefore, some changes
or improvements may not be covered in this manual. If you have questions
about operating characteristics or features that are different from those
described in this manual, please contact the REHAU distributor in your area
for assistance.
Product Standards
The tool with the attached battery is certified/listed under
UL 62841-1 and CSA C22.2.
The charger specified in this instruction manual is certified/listed under
UL 1012 and CSA 22.2 No. 107.2.
Other Symbols on the Power Tool
Volt
12V
Direct Current
Do not dispose of in the household trash.
10
All manuals and user guides at all-guides.com
Correction
Clean contacts when dry with a soft, dry cloth or brush
Send tool/battery to the service center
Re-insert battery; pay attention to locking mechanism
Charge battery
Send battery to the service center or have it recycled
Send tool/battery to the service center
Do not open the tool and do not remove or damage the tool seal; send tool to the
service center
Do not open the tool and do not remove or damage the tool seal;
send tool to the service center
Interrupt the process. Hold release button under tension and at the same time
continuously actuate the operating trigger for about 10 seconds. If this does not
correct the malfunction, send tool to the service center
Send tool to the service center
REHAU Technical Guidelines
For a full list of REHAU Technical Guidelines, please visit
www.na.rehau.com/resourcecenter.
Disposal
This product must not be disposed of in the household trash, but only in
accordance with local, state, and federal laws and regulations. Take the
power tool, accessories, and packaging to an approved disposal site for
environmentally friendly recycling.
Recycle depleted batteries promptly. Follow instructions in the DEWALT
instruction manual for recycling the battery and charger.
Limited Warranty
This product is sold subject to the REHAU PEXa Limited Warranty, available
at www.na.rehau.com/warranties. It can also be obtained from your
authorized REHAU distributor or by writing to REHAU Construction LLC,
1501 Edwards Ferry Road NE, Leesburg VA 20176 US.
Refer to the REHAU PEXa Limited Warranty for more information.
When sending parts for service, include original purchase documentation.
Contact DEWALT directly for warranty terms and conditions for the battery
and charger.
Trademarks
EVERLOC
license by REHAU Construction LLC.
DEWALT
Inc., or an affiliate thereof and are used under license.
This listing of trademarks is partial and is subject to change. Any unauthor-
ized use of these trademarks without express written consent is strictly
prohibited.
Customer Support
For customer support, contact your nearest REHAU Construction Sales
Office, available at www.na.rehau.com/contact.
and RAUPEX are registered trademarks and are used under
® ®
and the DEWALT logo are trademarks of Stanley Black & Decker,
®