Replacing The Cable With Central Adapter; Warnings - Cebora CP-70C Manual De Instrucciones

5.5

Replacing the cable with central adapter

J P AB
W
Remove spring P. Open the cover W by unscrewing the 4 set screws and then screw M. Remove pins of the control
cable X and Z. Take note of the position of each pin and then remove the U-bolt T and the pins of the pilot arc red
cables Y and Y1. Cut the isolating hose K2 and unscrew body N from fitting I1. Assemble the new fitting and follow
the previous instructions in reverse direction. Use thread sealer to lock the N body thread. To avoid jeopardizing the
safety efficiency, the body contacts N must be connected as follows: pins Y and Y1 of pilot arc red cables to
contacts 5 and 6, pin X of cable J to contact 1, pin Z of cable J to contact 9.
Reconnect U-bolt T as described above.
5.6

Warnings

Periodically make sure that the welding torch cable is intact and has no cuts or excessive wear. Replace it immediately
if needed.
T X
M I1 Y Y1
Fig. 10
Z N
K2
17