Product Operation - LUND 78890 Instrucciones Originales

GB
All manuals and user guides at all-guides.com
must match the power socket. Do not modify the plug. Do not use any power
adapters to adapt the plug to the socket. An unmodifi ed plug, which matches the
socket, reduces the risk of an electric shock.
A product with fi rst class electrical insulation must always be connected to an
outlet equipped with a protective conductor. The mains power supply should be
equipped with a residual current fuse with a tripping current of 30 mA or less.
After each application, unplug the power cord from the power socket. Always
disconnect the device from the power supply, if it is left unattended, and before
putting it away, disassembling, or cleaning.
Do not leave the device unattended when it is connected to the power supply.
Do not overload the power cord. Do not use the power cord to carry the prod-
uct, connect, or disconnect the plug from the power socket. Avoid any contact
between the power cord and heat sources, oil, sharp edges, and moving parts.
Damage to the power cord increases the risk of an electric shock. If the power
cord is damaged (e.g. it is cut, its insulation is melted), immediately unplug it from
the wall socket, and return it to an authorised service facility. It is not allowed to
use the product with a damaged power cord. It is not allowed to have the power
cord repaired. It must be changed for a new one at an authorized service centre.
Disconnect the power cord from the power socket, before installing, removing, or
adjusting any of the product accessories.
Make sure that the selected accessory has been installed correctly, before start-
ing the product.
Do not overload the product. The temperature of the housing must not exceed
60 C. Overloading the product will accelerate its wear and tear, lead to its dam-
O
aging, and increase the risk of an electric shock.
The product must be kept under supervision at all times during operation.
The product is not to be used by children. Keep the product and its power cord
out of the reach of children. It is important to ensure that children do not see the
product as a toy.
Children should not be allowed to clean or maintain the product without the su-
pervision of an adult.
Keep the device out of reach of children if it is powered or is cooling down.
This product cannot be used by people with impaired physical and/or mental abil-
ities, and by people without any experience in or understanding of the operation
of the product, unless they are supervised or instructed in the safe use of the
product, so that they understand the relevant operating risks.

PRODUCT OPERATION

Preparing the appliance for operation
Caution! All actions described in this section must be carried out with the product
unplugged. Make sure that the power cord has been unplugged from the socket.
The tip of the product should be completely cooled down.
Bend the central part of the stand upwards so that the arms of the bent part al-
lowed the device to be positioned. Place the device so that the arms are between
the housing, the metal ring on the heating element cover and the tip is directed
upwards (II).
The base has two holes that allow it to be mounted to the surface, e.g. by means
of screws.
Select one of the tips to be used for your application. The silver tip is used for
soldering with solder, and the gold tip is used for pyrography.
The tip must be screwed into the opening at the end of the heating element cover
(III) as far as possible. Tighten the tip without tools, e.g. pliers. The pliers can
damage the surface of the tip.
O R I G I N A L I N S T R U C T I O N S
11